[Jewelry making - Article 00219] - Re: [Orchid] Soldering tube settings together

[Helen Hill]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    Thanks for your reply James. 

    The solder I was sent, that I liked so much WAS sterling plumb
    solder and must have been made by PM West. Its credentials were
    stamped into the panels but I can't remember what it said as I cut it
    up into tiny pieces to keep in separate jars but sadly I've run out
    of the preferred hard plumb solder. Yes its melting point is
    extremely close to that of sterling but I like it and didn't
    accidentally melt anything as I was careful. Thanks for the heads up
    as to who makes it. 

Helen
UK
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________