[Jewelry making - Article 00153] - Re: [Orchid] Creating a cone

[David Huffman]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

Hi Leonid;

>     Start with the disc of the radius slightly larger to the length of
>     the side of the cone ( not the cone height ). Saw the disk from
>     the outside to the center. You must stop exactly at the center.
>     Using fingers start pushing sides of the cut towards each other and
>     past each other until the required cone with form. 

    That's brilliant! After reading your post, I realize that is exactly
    the best way to do it. 

David L. Huffman
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________