[Jewelry making - Article 00080] - Re: [Orchid] Soldering tube settings together

[R . E . Rourke]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    helen try Hoover and Strong for plumb solders..I'll procure it for
    you if they won't mail it direct..many vendors use H&S products as
    the solder they sell....... 

    tube settings can be held quite securely with jett sett or another
    fixturrirng thermoplastic..all you need is extremely hot water and
    the granules; place them in water remove when soft and workable and
    then create a jig to hold em..alternatively wet some shreded
    newsprint, wad it up squeeze out the excess arrange the tubes,flux
    well and solder as required then just toss the wadded paper... 

RER
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________