[Jewelry making - Article 00064] - Re: [Orchid] Precision scroll saw

[Charles Lyndon]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    Hi, Most any woodworking saw will do piercing, I highly recommend the
    Hawk precision scroll saw, it is one of the best on the market. 

    http://www.rbiwoodtools.com/scrollsaws.html 

    Also, Dremel make a small scroll saw but I have no first hand
    knowledge of that unit. 

    The scroll saw can handle most any project, it's all about using the
    right blades. 

    Hope this helps, 

Chuck
Charles Lyndon design
70" of snow so far this winter in Northern Maine...
and 10" more on the way tomorrow...WooHoo!
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________