[Jewelry making - Article 00029] - Re: [Orchid] [Source] Custom titanium bands

[RMS]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    Who ever said titanium was to hard to cut? If it is too hard to cut
    just how do rings get made? Where does this stuff come from? We cut
    Ti every day with a foot shear and jewelers saw. There are many
    grades of titanium none are as hard as hardened steel. Some is tough
    to cut, some isn't. Show me an actual case of a finger lost! Jeeez,
    been fighting for 25 years to dispose of weird "Things somebody
    heard, from somewhere, that happened to somebody. blah, blah, blah." 

    Any tool that will cut steel will cut titanium., Even the hardest of
    the alloys will fall to a simple cut off disk and Dremel tool. 

Bill, Deborah & Michele
Reactive Metals Studio, Inc
928-634-3434, 800-876-3434, 928-634-6734fx
http://www.reactivemetals.com
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________