[Jewelry making - Article 01192] - Re: [Orchid] Oxy does not feed into the flame

[R . E . Rourke]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    clean the small brass filter in the handpiece and if that doesn't
    cure it replace the filter entirely. your air gas mixer is the second
    place to clean. and if that doesn't do it, time to replace the nit
    and get a refund from the repair work that apparently didn't do the
    job it was supposed to do.. 

rer
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________