[Jewelry making - Article 01183] - [Orchid] Broken drill bits remover

[Julie Balonick]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

Hello All!!

    I just saw a product commercial on T.V.,for "Grabit" broken screw
    remover. 

    It was made of hardened tool steel, and looked like the perfect
    thing for removing broken drill bits from metal!!! 

    First, you cut/ burnish a cone shaped "seat", and then the other end
    has a cone shaped, double cut, bur-like grabbing tip.......basically,
    it bites into the broken drill, and then reverses it out of the
    hole....?, Unfortunately, the "Grabit" appears to be for much larger
    drills/ screws than we use for jewelry. 

    Does anyone know of a source for this type of thing for smaller
    sized drills? 

Best Regards,
Julie
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________