[Jewelry making - Article 01148] - Re: [Orchid] Creating a cone

[David Huffman]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

>     Isn't sitting down and figuring out the answer to conundrums like
>     this part of the magic and wonder of being a jeweler? 

    I had a nifty little DOS program that let you plug in height and base
    width and it would print out a template for you. It was stored on the
    drive of the computer that just died on me last week. I may be able
    to dig it out of a backup disk I have, but the computer was writing
    erroneous disks and making me believe everything was hunky-dory, so
    it may be unreadable. If I can resurect it, I'll post in on
    Ganoksin's FTP site, but check, it may be there already. It was
    called, naturally, "Cone" 

David L. Huffman (cursing Mr. Gates on a daily basis these days)
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________