[Jewelry making - Article 01131] - Re: [Orchid] Creating a cone

[coralnut]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    Please see following on how to make a specific sized cone. I use it
    in my classes. 

    To make a cone, you can also scribe an arc on a sheet of metal, cut
    it out and bend it into a cone. After making the cone, saw or file
    away four or six 'V's in the top to and bottom and prepare as above
    when using a tube. You can also solder prongs or other embellishments
    onto this very easy to make and versatile setting. 

Cheers, Don.
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________