[Jewelry making - Article 00481] - Re: [Orchid] I Shor Rolling mill

[KARAT46]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    Post an image or send me one. 

    Shor did not make any MILLs 

    They could have one private labeled it may be Italian or Spanish. 

    See what numbers are on the casting. The Roller width ? 

    Will need the Diameter as the gear size will depend on that. 

    Get the dimensions on the gear such as number of Teeth, Key Way,
    Width and Diameter. 

    This will help your search and reduce the other persons effort. 

Kenneth
Karat46
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________