[Jewelry making - Article 00454] - Re: [Orchid] I Shor Rolling mill

[Dave Arens]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

Hi Rodney,

>     It has two teeth broken off one of the gears. 

    Measure the width of the gear, the diameter of the gear & the shaft
    it's mounted on. Then count the teeth including the 2 missing. Armed
    with this info, see if any of the other mills on the market have a
    comparable gear. If you can find one with everything the same except
    the hole for the shaft, don't worry. A machine shop may be able to
    bore out the hole if it is too small or provide a bushing if the
    hole is to large. 

Dave
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________