[Jewelry making - Article 00445] - Re: [Orchid] I Shor Rolling mill

[Terry Ogden]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

Rodney

>     The mill was free but it has a problem. It has two teeth broken off
>     one of the gears. 

    If no one has one, you might try a local machining company or there
    may be metal casting clubs in your area that do iron, and casting
    companies that you could try. 

    Either way, good luck on your machine. 

Terry
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________