[Jewelry making - Article 00432] - Re: [Orchid] Ultrasonic cleaning after stone setting

[Lauren]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    I haven't heard anyone mention Ionic cleaners, which clean by
    electrolysis. The cleaning solution is not hot, and therefore is
    safe for even heat sensitive stones. 

    Mine is a Speedbrite. I use it for emerald and opal jewelry, mainly.
    I put them in there for a few minutes, which loosens up and
    dissolves most polishing compounds. I may use a toothbrush if they
    are still a little dirty. Then I rinse and blow them dry with a can
    of compressed air to avoid waterspots, if I can't steam them. 

    Ionics will also remove tarnish and antiquing from silver. I've
    revived quite a few awfully tarnished chains, charms, and other
    intricate pieces by using the Ionic, and then steaming off a layer of
    tarnish, and repeating that until it's bright white. Just make sure
    to change the cleaning solution often - it needs to be clean to work.

Lauren
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________