[Jewelry making - Article 00060] - Re: [Orchid] Hammer Textured Rolling Mill?

[John Donivan]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

>     At worst, some internal gearbox teeth will be sacrificed in the
>     name of research. (At least I hope that's all that might happen...
>     I haven't opened it up to see inside about what else could be
>     hurt). So, with a $400 Pepe (4:1 gearbox ratio), a $75 used
>     gearmotor, some spare parts and plenty of R&D 

    Dar, as you probably are aware, you are no doubt exceeding the
    torque capabilities of your mill. The gears, as you mention, yes,
    but also shafts, bushings and even the frame itself. Likely just a
    shortened lifespan, I'd think - hopefully not catastrophic failure.
    Just a comment that's likely not news to you - I for one am very
    impressed with your whole project, though.... 

http://www.donivanandmaggiora.com
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________