[Jewelry making - Article 00946] - [Orchid] Casting crucible needed for old machine

[Charles Friedman DDS]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    I have an old Torit vertical casting machine (#7 probably dating to
    th 1940's). I am looking for some new crucibles: they are 1.5 inches
    long about 1.25 inches wide and about 1 inch high. The capacity is
    about 18 dwt at which point it might start to run out the casting
    hole. I will modify an existing crucible if the exact fit is not
    available. Thanks for the help 

Charles Friedman DDS
Ventura by the Sea
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________