[Jewelry making - Article 00646] - Re: [Orchid] Customer is going to test my limits

[BeadStorm]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

>     by my calcualtions with the infinity sign going around the cross
>     would that not cross in the center of the cross? I have not been
>     able to draw it any other way. Therefore where should the diamond
>     go? 

    No, the crosspiece on a cross is 1/3 of the way down the bar. The
    infinity is 1/2 of the way down the bar. That leaves the actual
    crosspiece or between the crosspiece and the X of the infinity for
    the diamond. (Although I will admit that this design would probably
    look better on a tattoo than on a ring. Good luck!!) 

BBR - Sandi Graves
Stormcloud Trading (Beadstorm)
651-645-0343
St Paul, Minnesota
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________