[Jewelry making - Article 00460] - Re: [Orchid] Hitting the right ring size

[J Morley]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

Jonathan,

    First off did you file the ring evenly before sanding it? It is
    important to get the first steps done evenly and continue through all
    the steps that way. Are you flipping the ring on the mandrel. Turning
    it around as you sand so that both sides are even also if you sand
    the ring around the inside 10 times are you sanding it ten times on
    both sides. Do everything equally to all surfaces and it should come
    out equal in the end. 

Cheers
J
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________