[Jewelry making - Article 00315] - Re: [Orchid] Grizzly Sheet Metal Machine

[jesse Brennan]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    Put this on your wish list: http://www.diacro.com 

    look at the bench shears. these used to be the best small shears
    --being made again in Minnesota. 

    I have an 8 and a 12 inch hinge type which work fine for me-- I put
    an out feed table on with stops to cut fixed strips. I feed from the
    back opposite the school solution way. All tool users need to be
    wary of sellers claim for capacity. They often distort the truth. I
    saw one noted metal craftsmans 12 inch that had been badly distorted
    by attempting to cut something way beyond its true capacity. Most
    likely !/4 or thicker steel. He and his wife taught students so these
    probably did it in. 

jesse
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________