[Jewelry making - Article 00127] - [Orchid] Mold making on the cheap

[William Vance]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

Hello all,

    In Murray Bovins casting book he describes being able to vulcanize
    rubber molds in a home oven, is this a viable technique for a
    craftsman on a budget and will it yield satisfactory results. 

    Also if one wanted to go the route of rtv molds would painting the
    mixture directly on the model help attain good results if one did not
    have a bell jar vacuum. I have seen vibrating tables in the tools
    catalogs the small ones run about 80 dollars are these better than
    nothing at all. thanks in advance. 

William
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________