[Jewelry making - Article 00122] - Re: [Orchid] Debubblizing RTV mould compound

[Jwryrubber]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    twic - we used a clear rtv from akron rubber the bubbles would all
    rise to the top and Good morning Goo: 

    I highly value input from customers, so was pleased to see your
    comments relative to bubbles and lamp. 

    Although we often recommend using light bulbs to accelerate cure, it
    never occurred to me that the bubbles might boil out before the resin
    has a chance to cure. The timing must be a bit tricky. We've not
    tried this. 

    Can you tell me more about this method? 

    Are you still doing this? 

Warm regards,
Bill Mull
www.zerodproducts.com
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________