[Jewelry making - Article 00023] - Re: [Orchid] Grizzly Sheet Metal Machine

[gustavo hoefs]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    i bought one of these from a different retailer i think the desgin is
    more important than the brand any how the only part that was reliable
    was the slip roll at the top. the shear performed for the first
    several cuts and then sprung itself under load it says it will do 22
    ga mild steel but if you want it to last keep your thickness at about
    28 ga and no cuts more than 4" wide ( i imagine it would do ok with
    silver and gold but im not saying this ) . the best part of my whole
    3in1 affair was watching the the hoist on my buddy's scrap metal
    truck load the thing up onto the back of the truck ! PAY YER $$ &TAKE
    YER CHANCES 

goo
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________