[Jewelry making - Article 00022] - Re: [Orchid] Debubblizing RTV mould compound

[bill wismar]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    I thought I would add a little note on mixing RTV, this might have
    already been written about but I have never seen it. When I mix RTV I
    use a plastic sandwich bag, once the both materials are added push
    out the air and seal the bag. Start squishing the bag to mix, I then
    set it in a bowl to hold it up while I vacumn. It does not expand
    much because there is not much air to begin with. Then I cut a corner
    out of the bag and push the stuff out into the mold frame, (like a
    cake decorating bag) when you are done throw the bag away no messy
    cleaning.
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________