[Jewelry making - Article 00925] - Re: [Orchid] Rolling Mill Basics - The Square

[Jeff Demand]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

Helen,

    A draw bench is only a luxury until you have one. Mine is a boat
    trailer winch and a bit of lumber, about 3 feet long. It lives
    hanging from the rafters and when needed is clamped in the vice. No
    expensive draw tongs, just a hardware store common slip joint pair
    of pliers with a steel ring over the handles. Cheap (mainly scrounge
    parts, decorative paint the greatest expense :-), and it doesn't
    take up space. Making big heavy wall tube is not only possible now
    but fun. 

Jeff
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________