[Jewelry making - Article 00889] - Re: [Orchid] Non-Tapered Square File

[jesse Brennan]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    I have a small die filer: 

    http://www.statecollegecentral.com/metallathe/MLA-18.html 

    and have been adapting standard files for use since the factory ones
    are long gone.. I have been unable to find any true square ones to
    adapt. The machine pulls the file from what would be the point. Some
    small tapered ones can work since the tapered point goes into the
    adapter. Other wise pillar files can be used. The application they
    were used for has pretty well been taken over by CNC wire EDM and
    CNC milling. 

jesse
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________