[Jewelry making - Article 00435] - Re: [Orchid] Granulation problem

[Helen Hill]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

Hi Karen,

    Yes I am using sterling silver. 

>     If you place the heat directly at the bottom tip of your wire, any
>     dirt or grease can cause an uneven melting. 

    I'll try this thanks. 

>     The term "granulation" is NOT creating a rounded ball at the end
>     of a wire. 

    Yes I know this. I was saying that I have the same problem when I do
    granulation AND when I ball up a wire for making earrings. I have
    done both and have the same problem but as you say it may be due to
    the fact that I'm using sterling instead of fine silver. When I've
    done granulation, it turns out ok if I can position the "dent"
    underneath but sometimes the little devils move while heat is being
    applied. I'll use fine silver for doing granulation next time. 

Thanks for the tips.
Helen
UK
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________