[Jewelry making - Article 00352] - Re: [Orchid] What the Rolling Mill is About

[KARAT46]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    Jewelry is Jewelry wether Silver, Gold, Beads, Pearl, Shell,
    Plastic, Silicon or even PMC. 

    It does not matter what it is made of. I know that "12.23456 mm by
    8.3984785 mm" was just getting a point across. 

    There are no known Rolling Mills for Jewelers that open to these
    measurements. That is a mini mill will open to 4mm & monstrous big
    Cavallins open up to 8mm. 

    Your 12mm figure is almost 1/2". 

    Silversmithing to my knowledge covered not only Jewelry but Table
    Ware Flower Pots and whole lots of Gifts Artifacts like Staffs and
    Canes, Thrones and Chariots etc. 

    Goldsmithing is not limited to Jewerly alone. Temples, Pagodas,
    Dentistry, Electrical Conductor and Circuit Board manufacturers do
    use Rolling Mills too. 

    Jewelry is not what you make it with or the cost of the material
    used. 

Kenneth Singh
46 Jewelry Supply.
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________