[Jewelry making - Article 00269] - Re: [Orchid] What the Rolling Mill is About

[KARAT46]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

>     12.23456mm by 8.3984785mm - just exactly what I want. 

    Boy that is getting too precise and It would be tough make
    production run with those measurement. 

    Rolling mills are also used to put patterns on sheet and wire other
    than just making blanks metals. 

    I have seen some instructors twist wire and flatten to make a weave
    etc. 

    Imagination and Creativity is also essential part of being a good
    Jeweler. 

Kenneth Singh
46 Jewelry Supply
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________