[Jewelry making - Article 00096] - Re: [Orchid] Square Rings Sizes

[Veronica Kubat]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    A square ring is going to go on tighter because of a larger knuckle,
    but it will fit nicer because of the straight sides between the
    fingers. They will, because of the knuckle factor, not fit all
    customers the same. You put them on by turning them "sideways" or on
    a diagonal with the corners between the fingers and on top and
    bottom, then straighten it after it is on. 

    Try the size and a half bigger round and make it square and see what
    you get. 

Veronica
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________