[Jewelry making - Article 00047] - Re: [Orchid] Using Bonnie Doon Saw Guide

[Redpathdesign]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

>     Have the correct steel and instructions. What's the trick to using
>     this? I believe between my husband and myself,  within an hour we
>     broke 10 saw blades 

    I should have been more thorough when I wrote this last nite. The
    problem is when we have the base plate of the jig at the proper
    angle, we cannot see exactly where the saw blade is cutting. We've
    moved the lights, tried different chairs, etc. Because the saw is
    locked into the equipment it's hard to maneuver around. 

    Is this a common problem that just takes practice? 

Liane Redpath Worlund
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________