[Jewelry making - Article 01402] - [Orchid] Using Bonnie Doon Saw Guide

[Redpathdesign]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    Am in need of a few steel dyes done quickly so I don't have the turn
    around time to have them professionally done. Borrowed a friend's
    Bonnie Doon Jig. Have the correct steel and instructions. What's the
    trick to using this? I believe between my husband and myself, within
    an hour we broke 10 saw blades. Normally I am not one to break blades
    so not sure what we are doing wrong here. 

    Is there something else that works better for dye cutting? 

    Thanks in advance for your help. 

Liane Redpath-Worlund
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________