[Jewelry making - Article 01400] - Re: [Orchid] Square Rings Sizes

[Neilthejeweler]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    There is available a hollow rubber ring stake that might help you
    out. By jamming the square ring on the stake, the rubber deforms into
    the corners. It may not be precise in relation to round sizes but it
    can give you some consistency at least. I used that for a number of
    years with decent results. Come to think of it I haven't had a square
    ring cross my bench in quite a while. 

    I've seen metal square stakes but all square rings are not created
    equal so I would wonder about accuracy from one design to another.
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________