[Jewelry making - Article 01385] - Re: [Orchid] Which jump ring cutter will fit my flexshaft

[Ray Grossman]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

Dear Brett,

    The Jump Ringer requires a Foredom #30 handpiece. Many of the copies
    that are on the market look like it but are not exactly the same
    size. I suggest that you insist upon a genuine Foredom. If that
    handpiece will fit your flexshaft, you're in business. If it doesn't
    you'll need a Foredom #SR Flexshaft Kit. As far as an Australian
    supplier is concerned, I suggest you contact our Australian
    distributor, Selwyn Brandt the director of House of Jewellery, 89
    York St., Sydney (tel: 61-2-9299-6663). Selwyn is quite
    knowledgeable and a friendly helpful person. 

Ray Grossman
Ray Grossman Inc.
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________