[Jewelry making - Article 00426] - Re: [Orchid] Mold cutting ponderings

[Norah Kerr]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    The main section that I'm most worried about is half round and much
    wider then anything I have kicking about short of a file, but in
    size compared to the piece still might be an issue if there is a seam
    across it. 

    hrmmmmm maybe it's time I try my first 3 piece mould, unless there
    are any other suggestions. I'll be sure to count my fingers carefully
    before and after. *grins* 

Cheers,
Norah.
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________