[Jewelry making - Article 00230] - Re: [Orchid] Tools priorities

[fuzzi shu]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

Hi all -

    Well, just picked up an anvil in Omaha yesterday. Someone had
    responded to a Craigslist ad I posted a few weeks back. It was in
    pretty rough condition (completely rusted, edges eaten away) and I
    am trying to get it up to snuff. Wish I had a before and after
    picture. I haven't done much of the surface grinding yet, how do I
    clean it up without losing the tempering? Or is there a way to
    retemper it when I am done? This is at least a piece to start with. I
    was able to pick it up for a decent price and it's a Swedish cast
    anvil. Wish me luck and thanks again all for your help. 

Cheers
Rai
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________