[Jewelry making - Article 00162] - Re: [Orchid] Tools priorities

[jennifer friedman]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    My tool priorities are to buy quality tools one time. If you buy
    cheap tools (ie: chinese, india) then you will be replacing them
    sooner than later. Most of my hammers even quality have to be
    refinished. Everyone has their own standard of the tools they use.
    But quality (usually means more expensive) lasts and works longer and
    better. I have tools that are over 30 years old and still working
    fine. I have acquired over the years some cheap tools and they did
    not last long enough to even warrant the expenditure on them. 

jennifer friedman
http://www.jenniferfriedmanstudio.com
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________