[Jewelry making - Article 00115] - Re: [Orchid] Monarch CAD software

[Weldy Lopez]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

Hi Bill,

    Yes, not only by "Tony Nowles." There are actually several entries
    like this in the forum. You are right, there's just no comparison in
    terms of the software's capability, quality of service and training.
    THERE IS NO SOFTWARE LIKE IT OUT THERE! Many users of Matrix,
    3Design, etc recently switched over to Monarch. GET A DEMO & DECIDE
    FOR YOURSELF!
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________