[Jewelry making - Article 01744] - Re: [Orchid] Hanging motor or a bench motor?

[Sheila]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

Good Morning Orchidians

    I've been following this thread for a bit and have not seen anyone
    mention using a balancer system. It's a system using a track that can
    stretch as long as your bench and from that hangs one or more
    retractable things called balancers or tool positioners. The
    flexshafts, drills or whatever hang from the balancer and can be
    pulled along to anywhere on the bench. The retractable cable pulls
    the tool up out of the way when it's not being used and there is a
    dial to adjust the tension for pull-down. I've enclosed the web site
    for the kind we use at work for our drivers and air guns. This place
    has all the things you need to set up the system....and there is a
    Canadian site as well. 

    http://tinyurl.com/39p58s 

Hope this helps......Sheila
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________