[Jewelry making - Article 01730] - Re: [Orchid] Tools priorities

[jericcoleman]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    I use a rolling mill on a daily basis to make the size stock needed.
    Why file off excess when you can sve time and money on getting the
    proper thickness. If your time is valuable like mine don't draw out
    your wire. Order it. 

Thanks and good Luck Johneric
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________