[Jewelry making - Article 00833] - Re: [Orchid] Ideas on Lifting Tables for Booth Display

[R . E . Rourke]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    the most safe way would be to have a welder add some rod that is
    split at the bottom ( an inverted y) and mitered to be level and
    accept rubberized slip-on tips/ or coat in plasti-dip or a similar
    product for waterproofing and skid resistance, to the legs-- to
    raise,steady and add balanced support.Other contraptions are not as
    sturdy,don't follow the form of the legs and can be quite heavy and
    add more to break down at the end of a show..A welder that can then
    powder coat the legs is even better! 

R.E.R.
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________