[Jewelry making - Article 00774] - [Orchid] Strong polishing motor

[hans]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    I have a polishing motor that spins at 2800rpm and is simply too
    strong. I would like to make it weaker, or make it spin slower. When 
I
    was an apprentice, we had an induction polishing motor that had a
    slow or fast switch. It was great and we used it mostly on the slow
    speed. Does any one have any method that this can be achieved? I
    checked Rio's catalogue, but their motors also run at kamikaze
    speeds. 

Thanks, Hans Meevis
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________