[Jewelry making - Article 00490] - Re: [Orchid] Cutting Titanium

[RMS]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    Hey, I have been on vacation and not following this thread, but I
    looked on your web site at the piece you pictured. That is
    definitively "splash". It is found on the floor in titanium mills.
    It is heavily oxygenated, brittle and hard. I have a piece somewhere.
    Do you have a regular source for it? I guess I would go at it with
    stone cutting tools. They are cheap and readily available. You might
    find a lapidary shop to give it a try. Bill 

Bill, Deborah & Michele
Reactive Metals Studio, Inc
928-634-3434, 800-876-3434, 928-634-6734fx
http://www.reactivemetals.com
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________