[Jewelry making - Article 00393] - Re: [Orchid] Bolo tie fabrication

[TwoSunsTrd]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    Use round wire 14 gauge and rap it around a mandrel that will double
    the width of your bolo cord, cut off the first two full lopes of the
    wire and solder them on the back of the base metal. String the bolo
    cord through the lopes and spread the lopes so that there is tension
    on the cord so it will not slide after it is adjusted. 

    Hope this helps. 

    If you need any more information let me know. 

Lloyd.
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________