[Jewelry making - Article 00195] - [Orchid] Jel-Flux and Argentium Sterling Solder

[DC]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    I just wanted to add my positive experience with Jel-Flux from
    Pro-Craft and AS hard solder. This flux works better for me than any
    other flux I've tried. I'm getting full or near full flow with little
    or no skull. I think it may be worth a try if anyone else has had
    difficulty getting the AS hard solder to flow. I'm using a Smith
    oxy/air torch with a large-ish flame heating the work and then
    sweeping the flame back and forth along the seam with palions in
    place from the start. 

    I had been very frustrated with the hard solder until now. 

Peace, Dave
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________