[Jewelry making - Article 00071] - [Orchid] Moldy PMC3 Clay

[Justine Wetherington]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    Has anybody else opened up a package of PMC3 clay and found it had
    mold on it? I got one and cut off the moldy part and put it in
    distilled water under cover of glass and in no time at all the whole
    mass y looked like I was raising penicillin. I haven't tried (yet)
    to see if it cooks off when sintering. I wonder if it will leave a
    pattern. In my desgns I don't know that this would be a good thing. 

Justine
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________