[Jewelry making - Article 00014] - Re: [Orchid] How do you bend silver tubing?

[Carla M. Fox]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    2 questions come to mind when reading this thread. 

    Can one make their own springs out of brass to fit the exact size of
    tubing? If so what gauge would be good? 

    Can you shove a wire into the tube and bend it that way? 

Thanks.
Carla
www.carlamfox.com
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________