[Jewelry making - Article 01250] - Re: [Orchid] Hammer handles

[Gerald]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    very easy to keep the head in the wooden handle. place a nail with
    gnurled sides and just hit 'that' nail in the head! it will
    eventually SPREAD the wood as it is being displaced and you won't
    have any more problems...if and when it does, and might get loose
    again..just hit the handle (where you hold it) on the floor and the
    following momentum will drive 'that' nail deeper into the metal head
    just enough to make it TIGHT!..I suggest to hit the handle on a
    sturdy floor...not your bench top!... 

Gerry!
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________