[Jewelry making - Article 00251] - Re: [Orchid] Silver shoots all over the place

[Rodney Abel]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    One of your problems is the crucible is too far away from the flask
    when I use a centrifugal caster the nose of the crucible is inside
    the investment cone. This will also help with incomplete castings
    because you are not getting enough metal to the mold. I hope this
    helps 

Rod
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________