[Jewelry making - Article 00382] - Re: [Orchid] More about Jump Ringer

[Ray Grossman]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

In answer to Kelly's comments: 

>     I have never tried cutting square or triangular 'rings', but it
>     should not be too much different. Don't know about oval at all
>     maybe someone else has experience? I know the mandrels are out
>     there

    There is no way this can be done with Pepe's system. Shapes other
    than round must be cut on the mandrel and there is no provision made
    for controlling the depth of cut. With the Pepe tool you will either
    not fully cut through the wire or cut too deeply and chew up your
    mandrel. Although Pepe tried to copy our Jump Ringer, the parts are
    NOT interchangeable so once you purchase this system you cannot add
    accessories it to take advantage of the greater versatility and
    productivity of the Jump Ringer System. 

    You get what you pay for. 

Ray Grossman
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________