[Jewelry making - Article 00216] - Re: [Orchid] Selecting kiln for PMC

[BeadStorm]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    Suz - I have a Paragon SC2 and have used it for several years. I love
    it. I don't have the bead door because I don't need it, but I have
    been thinking about getting the window door (as a separate purchase)
    for my enamel work. The basic specs are: Temp range up to 2000
    degrees F (1093 degrees C) with an interior dimension of 8.0" wide x
    5.75" high x 7.75" deep. Because I purchased directly from Paragon, I
    didn't have any of the "pre-set" temperatures already programmed into
    the digital controller and I am happy about that since I use it for
    metal clay, enamel work and glass fusing, as well as kiln annealing
    of a lot of silverwork. 

Sandi Graves, Beadin' Up A Storm
Stormcloud Trading Co (Beadstorm)
http://www.beadstorm.com/
Saint Paul, Minnesota USA
651-645-0343
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________