[Jewelry making - Article 00194] - Re: [Orchid] Flexshaft speed control

[Sumner Silverman]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    Do you have a Foredom type flexshaft or a Foredom? I know that my
    Foredom can be controlled with either a foot pedal or a hand dial
    set up. There is an interrupt in the line going from the motor to the
    controlling device, i.e. either the foot pedal or hand dial,
    interchangeable. If your machine does not have that kind of a set
    up, you could add a three prong male plug to the wire exiting the
    motor, a female from the foot pedal, and get a hand controller from
    Foredom that already terminates in a three prong female plug. Check
    with Foredom to make sure that they are compatible.
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________